JVC DR-M1SL, Service Manual

Page: 6 / 56

1-6 (No.XA013)
SECTION 3
DISASSEMBLY
3.1 Main body section
3.1.1 Remove the top cover (See figure 1)
(1) Remove the four screws A attaching the top cover on both
sides of the main body.
(2) Remove the five screws B attaching the top cover on the
back of the main body.
(3) Raise the both sides and lower part of the rear of the top
cover, with opening them slightly in an outward direction.
And the top cover will be removed.
Fig.1
3.1.2 Remove the front panel assembly (See figure 2, figure 3)
• Prior to performing the following procedure, remove the top
cover.
• There is no need to remove the mechanism assembly.
(1) Disconnect the card wire from connector CN3002 on the
main board.
(2) Disconnect the card wire from connector CN7001 on the
FL display board.
(3) Hook a and b are removed respectively, and the front panel
assembly is removed.
Fig.2
Fig.3
B
B
A
x 2
A
x
2
B
B
B
Top cover Top cover
Front panel assembly
CN7001
CN3002
FL Display board
Main board
Hook a
Hook a
Hook b
Hook b
Front panel
assembly
Hook b