JVC DR-DX5SE, Instructions Manual

Page: 65 / 92

Masterpage:Right+
EN
65
Filename [DX5SEU_12Editing.fm]
EDITING
Page 65 Wednesday, 23 November 2005 14:13
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with
A DV AUDIO
REC
B
set to
A
12BIT
B
(
A
pg. 72).
1
Connect an audio device to the unit’s [AUDIO] input connectors
on the front panel.
●
When using a monaural audio device, connect its AUDIO OUT
connector to the [AUDIO-L] input connector on your unit.
2
Load a Mini DV cassette with the erase protection switch set to
A REC B .
3
Press DV/HDD/DVD SELECT on the unit repeatedly or DV on
the remote so that the DV lamp lights up on the unit.
4
Press PR +/– to select
A
F-1
B
.
5
Start playback slightly before the actual point from where you
wish to start dubbing.
6
Press
W
to pause playback.
7
Press A.DUB to engage the audio dubbing mode.
●
Your unit enters the Audio Dubbing Pause mode.
●
To perform Audio Dubbing with audio mixing, press AUDIO to
select
A
L
W X
R
B
at this point. When using the DV deck as the
recording deck, also make sure that A AUDIO MODE B is set to
A
SOUND1
B
(
A
pg. 72).
* Audio Dubbing with audio mixing is not possible if you are using a
monaural audio component, or if you don’t have an audio mixer.
8
Engage the audio device’s playback, then press
I
to start the
tape in the unit. Audio dubbing starts at this point.
●
To stop dubbing temporarily, press
W
. Press
I
to resume
dubbing.
9
Press
o
on the unit, then stop playback on the audio device to
end the audio dubbing.
NOTES:
●
Once the Audio Dubbing starts, you cannot use the other deck.
●
When monitoring the audio dubbed sound on the DV deck, set
A AUDIO MODE B to A SOUND2 B (
A
pg. 72).
●
Audio Dubbing is also possible with the [L-1 IN/OUT] or [L-2 IN/
DECODER] connector on the rear panel. When using these 21-
pin SCART connectors, be sure to select the correct input mode
(
A L-1 B or A L-2 B ) in step 4 .
●
When playing back an audio dubbed Mini DV tape on the DV
deck, set
A AUDIO MODE B to A SOUND2 B (
A
pg. 72).
●
Audio dubbing is not possible using the [DV IN/OUT] connector.
●
Audio dubbing is not possible on a blank portion of the tape.
Audio Dubbing (DV Deck Only)
ATTENTION:
You cannot perform Audio Dubbing on a tape that was recorded
with
A DV AUDIO REC B set to A 16BIT B (
A
pg. 72), on a tape that
was recorded at the
A
LP
B
speed, or on a blank tape.
PR +/-
PR +/-
AUDIO OUT
Audio cable
(not supplied)
Recorder
Mixer output
To [AUDIO]
input
Your unit
A.DUB
Original sound
Audio mixer
[AUDIO OUT]
Recorder
Your unit
To
[AUDIO]
input
CD player, etc.
CD player, etc.
A.DUB
●
Slide the TV/CABLE/SAT/DVD switch to DVD .
DX5SEU_00.book Page 65 Wednesday, November 23, 2005 2:13 PM