MX-G500
1-10
Turn the black loading pulley gear on the under side
of the CD changer unit in the direction of the arrow
and draw the CD tray toward the front until it stops.
Disconnect the card wire from connector CW103 on
the CD servo board.
Push down the two tray stoppers marked a and pull
out the CD tray.
1.
2.
3.
Align the gear-cam with the gear-tray as shown fig.4,
then mount the CD tray.
When assembling the CD tray, take extreme care not
engage with gear - synchro.
1.
2.
Prior to performing the following procedure, remove
the CD changer unit.
Removing the CD tray (See Fig.1 to 3)
Reinstall the CD tray (See Fig.4 to 5)
<CD changer unit>
Fig.2
Fig.1
Fig.3
Fig.4
Fig.5
Loading pulley gear
CD changer uint (reverse side)
CD servo board
CD tray
CW103
CD tray
CD tray
Gear-convert
Gear-convert
Gear-cam
Gear-tray
Gear-synchro
Gear-tray
Gear-tray
Gear-cam
timing point
CD tray
CD servo board
CW103
a
(Tray stopper)
a (Tray stopper)
