8
Basic and Common Operations
Setting the Clock
Before operating the unit any further, first set the unit’s clock.
When you plug in the power cord, “AM12:00” starts flashing
on the display.
You can set the clock when the unit is either turned on or in
standby mode.
On the remote control ONLY:
1
Press CLOCK/TIMER.
The hour indication starts flashing.
2
Press
4
or
¢
to adjust the
hour, then press SET.
• When you press and hold
4
or
¢
, the hour indication changes
continuously.
The minute indication starts flashing.
3
Press
4
or
¢
to adjust the
minute, then press SET.
• When you press and hold
4
or
¢
, the minute indication changes
continuously.
The built-in clock starts.
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to “AM12:00” right away. If this happens, set
the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
DISPLAY
CLOCK/
TIMER
SET
To show the clock when the unit is turned on
On the remote control ONLY:
Press DISPLAY.
• Each time you press the button, the display
changes the clock indication and the normal
indication alternately.
To adjust the clock
On the remote control ONLY:
1
Press CLOCK/TIMER repeatedly to
show the current time indication.
2
Press SET.
The hour indication starts flashing.
3
Press
4
or
¢
to adjust
the hour, then press SET.
The minute indication starts flashing.
4
Press
4
or
¢
to adjust the
minute, then press SET.
The built-in clock starts.
Turning On the Power
To turn on the unit,
press STANDBY/ON
.
The STANDBY lamp on the unit goes off.
• When you press the source button—CD
3
/
8
,
TAPE, FM/AM and AUX, the unit
automatically turns on.
To turn off the unit (standby), press STANDBY/ON
again.
The STANDBY lamp on the unit lights red.
• “AM12:00” flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on standby.
• A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely,
unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to “AM12:00” right away and “AM12:00” starts
flashing on the display when plugging the power cord again.
If this happens, set the clock again.
SET
CLOCK/
TIMER
STANDBY/ON
SET
SET
08-09_FS-G2[J]F.p65
04.11.5, 7:13 AM
8
