EN
65
TROUBLESHOOTING
Error – – This application will
close.
Check devices – – Confirm
that power is ON.
No devices detected to
connect.
Power ON all devices in
system.
Communication error
(&H (number))
Check cable connection.
Select the device to control.
No video cassette!!
Load a video cassette to ID
(number).
Invalid entry in scene
(number) (There is IN
>
OUT
condition). Correct the time
or delete the scene.
Select a number between 0
and 24.
Invalid frame number on drop
frame counter.
v
The COM port used for the JLIP connector is not
selected, or the COM port is selected but the
connection is wrong.
m
Check the connected COM port and select it on the
"Serial Port Selection" screen (
Z
pg. 46).
v
Power is not supplied or the connection is wrong.
m
Connect the devices correctly and turn them on
(
Z
pg. 42, 43).
v
Device is not turned on or cable is disconnected.
m
Connect the device correctly and turn it on
(
Z
pg. 42, 43).
m
If device was turned off and on again during
operation, click "OK". All devices should function
properly.
v
The line where the name of the device to use
appears is not clicked.
m
Click on it and "OK" (
Z
pg. 47).
v
The video cassette is not loaded in the camcorder.
When the video cassette is removed during
operation, this message appears.
m
Insert the video cassette into the camcorder.
v
The value of the CUT OUT point is smaller than
the CUT IN point's.
m
Set the value of the CUT OUT point so that it is
larger than the CUT IN point's (
Z
pg. 50, 54).
v
When correcting the CUT IN/OUT points, the
value you set differs from the original by over 25
frames.
m
Select integral number from 0 to 24 (
Z
pg. 54).
v
Because the DV-format digital camcorder uses the
drop frame system, inputting frame 00 and 01 is
impossible.
m
Input frame value other than 00 or 01
(
Z
pg. 48, 54).
MESSAGE
v
POSSIBLE CAUSE
m
CORRECTIVE ACTION
The monitor displays of the application software illustrated in this manual may differ from
those you are actually viewing depending on the operating environment of your computer.