Jupiter Variomaxx, Operating Instructions Manual

Page: 7 / 20

Subject to technical changes without notice; no responsibility is accepted for the accuracy of this information. 7
A
B
C
D
E
F
G
J
L
M
K
I H
Disassembly/assembly
1 Remove the splash guard lid L .
2 Press the release B downwards.
3
Raise the drive arm
A
upward, until it engages. 
click
On first disassembly:
Remove the mixing attachments
stored in the bowl J .
4
Turn the bowl
J
counter-clockwise.
 The bayonet fitting is released.
5
Remove the bowl
J
from the holder
H
.
If a mixing attachment is fitted:
6
Push the mixing attachment upwards against the spring.
7 Turn the mixing attachment one ¼ turn clockwise.
 The bayonet fitting is released.
8 Remove the mixing attachment from the drive shaft.
7
6
8
• The attachment can be assembled using the same steps
in reverse order.
Info:
In order to fold the drive arm back down again, you
must first press the release.
LCD display D
• In the top line of the LCD display, the processing time
elapsed, the preset time selected, or the remaining time
left of the preset time is displayed in minutes and sec-
onds.
• In the bottom line, the currently set speed level (
0 - 12
)
is displayed as a bar diagram and in decimal format.
+ and - buttons D
By pressing the + and - buttons, you can pre-set a time
for processing, which is then displayed on the LCD display:
• 0 - 20 min  in 30 s steps
• 20 - 90 min  in 5 min steps
Info:
• The time setting 20 - 90 min is only of relevance for the
Timer
and
Stopwatch
functions (see page 8)
• You can reset the preset time by simultaneously pressing
the + and - buttons to
00:00 .
Rotary knob for speed setting E
With the rotary knob, you can set the speed levels 0 - 12
and start or stop the appliance.
CAUTION Rotating parts can cause injury!
• Processing starts immediately once the knob is turned
from position
0 !
• If you turn the rotary knob to position 0 during process-
ing, processing stops and the elapsed processing time
or the remaining time left of the preset time is set to
00:00 .
• You can change the speed level at any time.
PAUSE/START button F
• By pressing the PAUSE/START button, you can stop and
restart the currently running processing and the
Timer
and Stopwatch functions.
• The time displayed on the LCD display is stopped by
pressing the PAUSE/START button and continues to run
once the button is pressed again.
Accessory connector M
All original Jupiter attachments can be fitted to the acces-
sory connector using the adapter supplied.
• Remove the cover from the accessory connector M and
store it in holder
C
.
• Fit the supplied adapter to the accessory connector
(bayonet fitting, ¼ turn counter-clockwise).