JA95-N70 Audio Controller with RX Volume Controls - NVG
Installation and Operating Manual
Rev
C
Page 19
(4)
Mode Switch
This is a red two-position locking toggle switch. When
set to the ‘up’ position, the unit is Emergency mode,
and when set to the ‘down’ position, the unit is in
Normal mode. The legends are interchangeable to
allow customization. (Default – EMER, NORM.)
The switch is locked to prevent accidental changing of
the mode. The switch must be lifted to release the lock.
For full information on Emergency and Normal Mode
operation, see sections
below.
(5)
Multi-function (Transmit/ICS) Switch
This is a green two-position centre-off momentary toggle
switch.
When in the default XMIT/ICS configuration, this switch
acts as the pilot’s ‘Press-to-talk’ (PTT) button. The unit
will transmit on the selected transceiver when the switch
is held in the ‘up’ position, and when held in the ‘down’
position, it will transmit on the intercom.
See
below for Multi-function Switch operation.
Note
: At installation, this switch may be configured to operate in default or alternative mode. Check with
your installing agency for confirmation of the operation of this switch. The legends are interchangeable to
allow customization.
(6)
Music/Configuration Connector (
♫
/io)
This is a music input that is compatible with most music players.
It accepts a 3 pole 3.5mm stereo plug with a slim diameter
connector housing.
(This connector is also used during installation to change
configuration settings.)
CAUTION
:
If an unapproved connector or cable is used, damage to the unit or to any attached device may
occur. If in doubt, contact JAC for a list of approved cables, music sources and devices.
(7)
Transmit Annunciator - TX
This is a deadfront annunciator that will illuminate when
the JA97-002 is transmitting.
The default legend is ‘TX’, but it is interchangeable to
allow customization.
