Problem
Possible cause
Remedy
The fuse is blown.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
You do not set the heat setting for
10 seconds.
Activate the hob again and set the
heat setting in less than 10 sec‐
onds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
Pause operates.
Refer to "Daily use".
There is water or fat stains on the
control panel.
Clean the control panel.
You can hear a constant beep
noise.
The electrical connection is incor‐
rect.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
You put something on one or
more sensor fields.
Remove the object from the sensor
fields.
The hob deactivates.
You put something on the sensor
field
.
Remove the object from the sensor
field.
Residual heat indicator does
not come on.
The zone is not hot because it op‐
erated only for a short time or the
sensor is damaged.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
You use a very tall pot which
blocks the signal.
Use a smaller pot, change the cook‐
ing zone or operate the hood man‐
ually.
Automatic Heat Up does not
operate.
The highest heat setting is set.
The highest heat setting has the
same power as the function.
The zone is hot.
Let the zone become sufficiently
cool.
The heat setting changes be‐
tween two levels.
Power management operates.
Refer to "Daily use".
The control panel becomes
hot to the touch.
The cookware is too large or you
put it too close to the control pan‐
el.
Put large cookware on the rear
zones, if possible.
comes on.
Child Safety Device or Lock oper‐
ates.
Refer to "Daily use".
16 ENGLISH
