14
Apply covers (B) on joint cover lugs and into hinge
holes.
Fig. 6
Position the runners (H) at the top and bottom of the
inside of the kitchen unit as shown in Fig. 7 and mark
the position of the external holes.
After preparing the holes, screw the runners to the
kitchen unit door using 3.5x16 mm screws.
Fig. 7
Open both the appliance door and that of the kitchen
unit to approx. 90
°
.
Place the little plates over the runners. Hold the doors
of the appliance and the unit together and mark the
holes.
Fig. 8
D013
B
D094
20mm
H
8mm
D415
Remove the little plates and make the holes with a di-
am. of 2 mm. Replace the little plates over the runners
and screw in the screws provided (3.5x16 mm).
For the alignment of the kitchen unit door, if neces-
sary, use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
Fig. 9
Inner door reversal
(Fig. 10)
Slide out pin (1).
Remove the inner door, taking care that pin (4) does
not fall.
Remove bush (5) and fit it into the opposite corner of
the door.
Remove catch (3) by undoing the screw and refit it on
the opposite side.
Move pin (4) to the hole in the opposite side of the
door.
Position the door pressing pin (1) into place.
Fig. 10
D416
3
2
4
1
5
D164
