7. Repeat Step 2 through Step 6 if you need to install a second VCCI module.
8. Power on the external Routing Engine. See
“Powering On an XRE200 External Routing Engine” on
Figure 37: Installing a VCCI Module in an XRE200 External Routing Engine
g020967
Tighten captive screws.
Removing an HDD Module from an XRE200 External Routing Engine
XRE200 External Routing Engines support up to two hard disk drive (HDD) modules on the front panel.
The HDD modules are hot-insertable and hot-removable field-replaceable units (FRUs).
Ensure that you have the following parts and tools available to remove an HDD module:
•
Phillips (+) screwdriver, number 2
•
An antistatic bag or an antistatic mat
CAUTION:
A single HDD module must be installed in a powered-on XRE200 External
Routing Engine. Removing both HDD modules when the external Routing Engine is
powered on can cause severe hardware issues.
To remove an HDD module from an external Routing Engine (see
):
1. Place the antistatic bag or the antistatic mat on a flat, stable surface.
2. A powered-on XRE200 External Routing Engine always requires at least one operational HDD module.
If the switch is powered on, perform this procedure only if an operational HDD module is working in
the other HDD module slot. If you are removing the only operational HDD module, power off the
external Routing Engine. See
“Powering Off an XRE200 External Routing Engine” on page 115
102
Summary of Contents for XRE200 -
