Juniper WLA532, Hardware Documentation

Page: 26 / 43

WLA532 Access Point Radio Frequency Exposure Guidelines
The following are Radio Frequency Exposure Guidelines for the WLA532 access point:
WLA Radio Safety Advisories:
Federal Communications Commission (FCC) Docket 96-8 for Spread Spectrum
Transmitters specifies a safety standard for human exposure to radio frequency
electromagnetic energy emitted by FCC-certified equipment. When used with the proper
antennas (shipped in the product), Juniper Networks MP access point products meet
the uncontrolled environmental limits found in OET-65 and ANSI C95.1-1991. Proper
installation of the access point according to the instructions in this manual will result in
user exposure that is below the FCC recommended limits.
Article 12- Without permission granted by the NCC, any company, enterprise, or user is
not allowed to change frequency, enhance transmitting power or alter original
characteristic as well as performance to an approved low power radio-frequency devices.
Article 14- The low power radio-frequency devices shall not influence aircraft security
and interfere legal communications; If found, the user shall cease operating immediately
until no interference is achieved. The said legal communications means radio
communications is operated in compliance with the Telecommunications Act. The low
power radio-frequency devices must be susceptible with the interference from legal
communications or ISM radio wave radiated devices.
4.7.5- Within the 5.25-5.35 GHz band, U-NII devices will be restricted to indoor operations
to reduce any potential for harmful interference to co-channel MSS operations.
4.7.6- The operation of the U-NII devices is subject to the conditions that no harmful
interference is caused. The user must stop operating the device immediately should
Copyright © 2011, Juniper Networks, Inc. 26
WLA 532 Access Point Hardware Documentation