STRM Series II Hardware Installation Guide
14
I
NSTALLING
AND
C
ONNECTING
THE
STRM H
ARDWARE
Installing the
Hardware
Place the shipping container on a flat surface and remove the hardware components
with care.
To install the STRM appliance:
Step 1
Mount the STRM appliance in your server rack using the attached mounting
brackets.
Step 2
Plug the power cord into the AC receptacle on the rear panel. See
Figure 8
.
If your STRM contains two power supplies, plug a power cord into each of the AC
receptacles.
Figure 8 Rear Panel of STRM 500 II
Step 3
Plug the other end of the power cord into a wall socket.
If your STRM appliance contains two power supplies, plug each power cord into a
separate power circuit to ensure that the device continues to receive power if one
of the power circuits fails.
Step 4
Plug the Ethernet cable into the port labeled ETH0 on the front panel. See
Figure 9
.
23
Telnet connection to
new managed device
Yes
No
Yes
53
DNS lookups
Yes
No
No
80
System Security
Updates from Juniper
Networks
Yes
Yes
Yes
123
Network Time Protocol
(NTP) time
synchronization
Yes
Yes
Yes
Table 11 Required Ports of STRM
Direction Port
Description
LAN
Internet
Depends on
Configuration
g040042
AC Power supply
receptacle
AC Power
switch
