Juniper SRX340, Hardware Manual

Page: 56 / 150

Table 13: RJ-45 Connector Pinouts for the SRX340 Services Gateway
Console Port
Description Signal Pin
Request to Send RTS 1
Data Terminal Ready DTR 2
Transmit Data TXD 3
Signal Ground Ground 4
Signal Ground Ground 5
Receive Data RXD 6
Data Set Ready DSR/DCD 7
Clear to Send CTS 8
Related
Documentation
RJ-45 Connector Pinouts for the SRX340 Services Gateway Console Port on page 37
•
•
Mini-USB Connector Pinouts for the SRX340 Services Gateway Console Port on page 38
Mini-USB Connector Pinouts for the SRX340 Services Gateway Console Port
The SRX340 Services Gateway has two console ports: an RJ-45 Ethernet port and a
mini-USB Type-B port. If your management device (laptop or PC) does not have a DB-9
male connector pin or an RJ-45 connector pin, you can connect your management device
to the Mini-USB Type-B console port of the services gateway by using a cable that has
a standard Type-A USB connector on one end and a Mini-USB Type-B (5-pin) connector
on the other end.
Table 14 on page 38 describes the Mini-USB Type-B connector pinouts
for the console port.
NOTE: By design, the mini-USB console port has higher priority over the RJ-45
console port. If the mini-USB and RJ-45 console ports are both connected,
then the mini-USB console port will be active.
Table 14: Mini-USB Type-B Connector Pinouts for the Services Gateway
Console Port
Description Cable Color Signal Pin
+5 VDC Red VCC 1
Data - White D- 2
Data + Green D+ 3
Copyright © 2016, Juniper Networks, Inc. 38
SRX340 Services Gateway Hardware Guide