Juniper QFX5110, Hardware Manual

Page: 169 / 222

Table 35: Chassis Alarm Messages (continued)
Recommended Action CLI Message Alarm Type Component
Check the system log for the following
error message and report the message
to customer support:
Temp sensor sensor-number failed
, where
sensor-number ranges from 1 through 10.
sensor-location Temp Sensor Fail Major (red) Temperature
sensors
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) do not
affect the temperature sensor. If the
condition persists, the device might shut
down. sensor-location Temp Sensor Too Hot
Check environmental conditions and
alarms on other devices. Ensure that
environmental factors (such as hot air
blowing around the equipment) do not
affect the temperature sensor.
sensor-location Temp Sensor Too Warm
Minor (yellow)
Clean up the system file storage space
on the switch. For more information, see
Cleaning Up the System File Storage
Space
.
RE RE number /var partition usage is high
Minor (yellow) Routing Engine
Clean up the system file storage space
on the switch. For more information, see
Cleaning Up the System File Storage
Space
.
RE RE number /var partition is full
Major (red)
Use the request system configuration
rescue save command to set the rescue
configuration. For more information, see
Setting or Deleting the Rescue
Configuration
.
Rescue configuration is not set Minor (yellow)
Install the required license for the feature
specified in the alarm. For more
information, see
Software Features That
Require Licenses on the QFX Series .
Feature usage requires a license
or
License for feature expired
149 Copyright © 2017, Juniper Networks, Inc.
Chapter 19: Alarm Messages