Figure 11: Removing Lower Fan Trays
g007039
WARNING:
Before removing a fan tray, make sure that the fan blades have
stopped completely.
NOTE:
For complete instructions on removing router components, see the
MX2008 3D Universal Edge Router Hardware Guide.
Install the Router by Using a Pallet Jack with Attachment
•
Install the Pallet Jack Attachment on page 20
•
Use the Pallet Jack with Attachment to Install the Router on page 21
Install the Pallet Jack Attachment
1.
Remove the pallet jack attachment from the shipping crate.
2.
Place the pallet jack attachment across both pallet jack legs.
3.
Using a 9/16-in. (14 mm) socket wrench, loosen and remove the eight torque fasteners
for bracket support that are located on the top of the pallet jack attachment platform.
4.
Using a 9/16-in. (14 mm) socket wrench, loosen the torque fasteners that are located
on the four adjustable pallet jack attachment brackets.
5.
Adjust the four pallet jack attachment brackets until they fit under the pallet jack legs.
6.
Tighten the torque fasteners using a 9/16-in. (14 mm) socket wrench to secure the
brackets on the pallet jack attachment to the pallet jack (see
Copyright © 2017, Juniper Networks, Inc.
20
MX2008 3D Universal Edge Router Quick Start
