Juniper JRR200, Hardware Manual

Page: 18 / 108

•
DC power supply units
• Fan trays
JRR200 Chassis
• JRR200 Route Reflector Chassis Front Panel on page 18
• JRR200 Route Reflector Chassis Rear Panel on page 20
•
JRR200 Route Reflector Physical Specifications on page 21
JRR200 Route Reflector Chassis Front Panel
Figure 1 on page 18 shows the front panel of the JRR200 route reflector.
Figure 1: JRR200 Route Reflector Front Panel
g100148
5 6
1 2
7
3
4
Table 3 on page 18 lists the components on the front panel of the JRR200 route reflector.
Table 3: JRR200 Route Reflector Components on the Front Panel
Description Component Number
Gigabit Ethernet port to connect to the device over the
network. Management port 1
Two USB 2.0 ports that accept a USB storage device. USB ports 2
The two HA ports are not supported on the JRR200 route
reflector. HA ports 3
Eight 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ ports for
network traffic. SFP+ ports 4
Indicate component and system status at a glance. LEDs 5
Connects a laptop to the JRR200 route reflector for CLI
management. The port uses an RJ-45 serial connection, is
configured as DTE, and supports the RS-232 (EIA-232)
standard. Console port 6
Returns the JRR200 route reflector to the factory-default
configuration.
RESET
button 7
Copyright © 2018, Juniper Networks, Inc. 18
JRR200 Route Reflector Hardware Guide