Juniper JRR200, Hardware Manual

Page: 20 / 108

Network Port LEDs
Each SFP+ port has two status LEDs located above the port. Table 6 on page 20 describes
the LEDs. Figure 3 on page 20 shows the LEDs.
Figure 3: Network Port LEDs
Table 6: Network Port LEDs
Description LED Callout
• Solid green—There is link activity.
• Off—There is no link established.
Link (LED on the
left) 1
• Solid amber—10G/1G link is established.
• Blinking amber—There is activity on the 10G/1G link.
• Off—There is no link established.
Speed/Activity
(LED on the
right) 2
JRR200 Route Reflector Chassis Rear Panel
Figure 4 on page 20 shows the rear panel of the JRR200 Route Reflector.
Table 7 on page 20 lists and describes the rear panel components.
Figure 4: JRR200 Route Reflector Rear Panel
Table 7: JRR200 Route Reflector Rear Panel Components
Description Component Number
Connects the JRR200 route reflector chassis to earth ground. Grounding point 1
Use the Power switch to power on or power off the JRR200 route
reflector. Power switch 2
Copyright © 2018, Juniper Networks, Inc. 20
JRR200 Route Reflector Hardware Guide