background image

How to Set Up Your CBA850 3G/4G/LTE Wireless WAN Bridge

7

Regulatory and Safety Information

Read all operating instructions and the safety 
information below and before using the CBA850 
device to avoid injury.

FEDERAL COMMUNICATION COMMISSION 
INTERFERENCE STATEMENT

: This equipment 

has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of 
the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference 
in a residential installation. This equipment 
generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance 
with the instructions, may cause harmful 
interference to radio communications. However, 
there is no guarantee that interference will not occur 
in a particular installation. If this equipment does 
cause harmful interference to radio or television 
reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try 
to correct the interference by one of the following 
measures:

 

Reorient or relocate the receiving antenna.

 

Increase the separation between the equipment 
and receiver.

 

Connect the equipment into an outlet on a circuit 
different from that to which the receiver is 
connected.

 

Consult the dealer or an experienced radio/TV 
technician for help.

FCC CAUTION:

 Any changes or modifications 

not expressly approved by the party responsible 
for compliance could void the user’s authority to 
operate this equipment.

This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.

FCC Radiation Exposure Statement

: This 

equipment complies with FCC radiation exposure 
limits set forth for an uncontrolled environment. 
This equipment should be installed and operated 
with a minimum distance of 20 cm between the 
radiator and your body.

To comply with FCC regulations limiting both 
maximum RF output power and human exposure 
to RF radiation, for the CBA850-LE the maximum 
antenna gain must not exceed 8 dBi in the cellular 
band, 3 dBi in the PCS band and 10 dBi in the LTE 
band. For the CBA850-LP the maximum antenna 
gain including cable loss must not exceed 7.5 dBi 
in the cellular band, 3 dBi in the PCS band, 5.5 dBi 
in LTE Band 4, and 9 dBi in LTE Band 17. For the 
CBA850-W the maximum antenna gain must not 
exceed 9.2 dBi in the 2.5 GHz band (2496-2690 
MHz).

SAFETY AND HAZARDS: 

Under no circumstances 

should the CBA850 device be used in any areas (a) 
where blasting is in progress, (b) where explosive 
atmospheres may be present, or (c) that are near 
(i) medical or life support equipment, or (ii) any 
equipment which may be susceptible to any form of 
radio interference. In such areas, the CBA850 device 
MUST BE POWERED OFF AT ALL TIMES (since 
the device otherwise could transmit signals that 
might interfere with such equipment). In addition, 
under no circumstances should the CBA850 device 
be used in any aircraft, regardless of whether the 
aircraft is on the ground or in flight. In any aircraft, 
the CBA750B device MUST BE POWERED OFF 
AT ALL TIMES (since the device otherwise could 
transmit signals that might interfere with various 
onboard systems on such aircraft). Furthermore, 
under no circumstances should the CBA850 device 
be used by the driver or operator of any vehicle. 
Such use of the device will detract from the driver’s 
or operator’s control of that vehicle. In some 
jurisdictions, use of the CBA850 device while driving 
or operating a vehicle constitutes a civil and/or 
criminal offense.

Due to the nature of wireless communications, 
transmission and reception of data by the CBA850 
device can never be guaranteed, and it is possible 
that data communicated or transmitted wirelessly 
may be delayed, corrupted (i.e., contain errors), or 
totally lost. The CBA850 device is not intended 
for, and CradlePoint recommends the device 
not be used in, any critical applications where 
failure to transmit or receive data could result in 
property damage or loss or personal injury of any 
kind (including death) to the user or to any other 
party. CradlePoint expressly disclaims liability for 
damages of any kind resulting from: (a) delays, 
errors, or losses of any data transmitted or received 
using the device; or (b) any failure of the device to 
transmit or receive such data.

Warning:

 This product is only to be installed by 

qualified personnel!

Industry Canada Statement

This device complies with RSS-210, RSS-102, and 
RSS-Gen of the Industry Canada Rules. Operation 
is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) 
this device must accept any interference received, 
including interference that may cause undesired 
operation.

Déclaration d’Industrie Canada

Ce dispositif est conforme à la norme CNR-
210, CNR-102, et CNR-Gen d’Industrie Canada 
applicable aux appareils radio exempts de 
licence. Son fonctionnement est sujet aux deux 
conditions suivantes: (1) le dispositif ne doit pas 
produire de brouillage préjudiciable, et (2) ce 
dispositif doit accepter tout brouillage reçu, y 
compris un brouillage susceptible de provoquer un 
fonctionnement indésirable.

Summary of Contents for CBA850









Reviews: