JUNIOR JNR mini-beam 230, User Manual

Page: 8 / 8

.07.
Clamp mounting:
assembly that integrates the bottom of the base, the included “Omega Bracket,” and
the safety cable rigging point in one unit (see the illustration below). When mounting
this fixture to truss be sure to secure an appropriately rated clamp to the included
omega bracket using a M10 screw fitted through the center hole of the “omega
bracket”. As an added safety measure be sure to attached at least one properly rated
safety cable to the fixture using on of the safety cable rigging point integrated in the
base assembly.
Regardless of the rigging option you choose for your JNR , always be
sure to secure your fixture with a safety cable. The fixture provides a built-in rigging
point for a safety cable on the hanging bracket as illustrated above. Be sure to only
use the designated rigging point for the safety cable and never secure a safety cable
to a carr ying handle.
The JNR provides two unique mounting bracket MINI BEAM 230
MINI BEAM 230
②
① Omega Bracket
②
Satety Clamp
③
Safety Cable
④ 1 / 4 Turn Quick - Lock Fasteners
①
③
④
1/4 Turn 1/4 Turn
.08.
Connect the provided XLR cable to the female 3-pin XLR output of your controller
and the other side to the male 3-pin XLR input of the moving head. You can chain
multiple Moving head together through serial linking. The cable needed should be
two core, screened cable with XLR input and output connectors. Please refer to the
diagram below.
DMX-512 connection with DMX terminator
DMX-512 CONTROL CONNECTIONS 7
DMX Output
3-Pin XLR Socket
DMX Input
3-Pin XLR Socket
1:Ground
2:Data(-)
3:Data(+)
1 2
3
1 2
3
1
2
3
1
2
3
COMMON
DMX+
DMX-
DMX512 IN
3-PIN XLR
DMX512 OUT
3-PIN XLR
For installations where the DMX cable has to run a long
distance or is in an electrically noisy environment, such as in a
discotheque, it is recommended to use a DMX terminator.
This helps in preventing corruption of the digital control
signal by electrical noise. The DMX terminator is simply an
XLR plug with a 120 Ω resistor connected between pins 2 and
3,which is then plugged into the output XLR socket of the last
fixture in the chain. Please see illustrations below.
1 2
3
PIN3
PIN2
120
Ω
DMX IN
DMX OUT
POWER IN
POWER OUT
FUSE
POWER SWITCH
SIGNAL
SELECT
DMX IN
POWER IN
WI-ANTENNA