Jungheinrich EZS 330 XL, Operating Instructions Manual, Page: 31 / 85

0406
.GB
E 4
3 Starting up the truck
F
Before the truck can be commissioned or operated, the driver must ensure that there
is nobody within the hazardous area.
The electronic traction controller and optionally the steering controller monitor their
own operation. In the event of an error, travel and steering are interrupted.
F
The error that has occurred must be eliminated by the manufacturer's service
department.
Checks and operations to be performed before starting daily work
– Inspect the entire truck (especially the wheels) for visible signs of damage.
– Visually inspect the battery attachment and cable connections
M
When entering the truck, take care not to activate the controller or the
“pedestrian” (
o
) button.
Switching on the truck
– Step onto the operator platform (20).
– After relaxing the tiller adjustment device, set the tiller to the required position and
then release the tiller adjustment device.
– Pull out the main switch / isolator (19).
– Insert the key in the key switch (18) and turn it clockwise as far as it will go to the
“I” position.
– Test the horn (15).
– Test the controller (16) (see section 4.2).
The truck is now operational.
Z
The display instrument (CANDIS (17/(
o
)) shows the available battery capacity.
15
16 17 18
19
20
0406
.GB
E 4
3 Starting up the truck
F
Before the truck can be commissioned or operated, the driver must ensure that there
is nobody within the hazardous area.
The electronic traction controller and optionally the steering controller monitor their
own operation. In the event of an error, travel and steering are interrupted.
F
The error that has occurred must be eliminated by the manufacturer's service
department.
Checks and operations to be performed before starting daily work
– Inspect the entire truck (especially the wheels) for visible signs of damage.
– Visually inspect the battery attachment and cable connections
M
When entering the truck, take care not to activate the controller or the
“pedestrian” (
o
) button.
Switching on the truck
– Step onto the operator platform (20).
– After relaxing the tiller adjustment device, set the tiller to the required position and
then release the tiller adjustment device.
– Pull out the main switch / isolator (19).
– Insert the key in the key switch (18) and turn it clockwise as far as it will go to the
“I” position.
– Test the horn (15).
– Test the controller (16) (see section 4.2).
The truck is now operational.
Z
The display instrument (CANDIS (17/(
o
)) shows the available battery capacity.
15
16 17 18
19
20