Jungheinrich EZS 330 XL, Operating Instructions Manual, Page: 20 / 85

C 3
0406
.GB
4 Operating the truck without its own drive system
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failure has rendered it immobile, proceed as
follows:
– Set the master switch to position “OFF”.
– Set the key switch to position “OFF” (“0”) and remove
the key.
– Prevent the truck from rolling away.
– Open battery cover (refer to chapter D).
– Open the front cover (7) and put it to one side (see chapter F).
– Slacken the lock nuts (8) and tighten the screws (9).
The brake is now released and the truck can move.
F
On reaching your destination, ensure that the brake is restored to its initial state. The
truck must never be parked with the brakes released.
– Loosen the screws (9) by approx. 5 mm and lock by tightening the lock nuts (8).
The brake is now applied again.
– Refit the front cover (7).
7
8
9
C 3
0406
.GB
4 Operating the truck without its own drive system
F
This operating mode is not permitted when negotiating inclines and gradients.
If the truck has to be moved after a failure has rendered it immobile, proceed as
follows:
– Set the master switch to position “OFF”.
– Set the key switch to position “OFF” (“0”) and remove
the key.
– Prevent the truck from rolling away.
– Open battery cover (refer to chapter D).
– Open the front cover (7) and put it to one side (see chapter F).
– Slacken the lock nuts (8) and tighten the screws (9).
The brake is now released and the truck can move.
F
On reaching your destination, ensure that the brake is restored to its initial state. The
truck must never be parked with the brakes released.
– Loosen the screws (9) by approx. 5 mm and lock by tightening the lock nuts (8).
The brake is now applied again.
– Refit the front cover (7).
7
8
9