Jungheinrich ESD 220, Operating Instructions Manual

Page: 126 / 186

3.1 Working on the electrical system
WARNING!
Electrical current can cause accidents
Make sure the electrical system is voltage-free before starting work on it. The
capacitors in the controller must be completely discharged. The capacitors are
completely discharged after approximately 10 minutes. Before starting maintenance
on the electrical system:
u Only suitably trained electricians may operate on the truck's electrical system.
u Before working on the electrical system, take all precautionary measures to avoid
electric shocks.
u
Park the truck securely (see page 67).
u Remove the battery, see page 47.
u Remove any rings, metal wristbands etc.
3.2 Consumables and used parts
CAUTION!
Consumables and used parts are an environmental hazard
Used parts and consumables must be disposed of in accordance with the applicable
environmental-protection regulations. Oil changes should be carried out by the
manufacturer's customer service department, whose staff are specially trained for
this task.
u
Note the safety regulations when handling these materials.
3.3 Wheels
WARNING!
The use of wheels that do not match the manufacturer's specifications can
result in accidents
The quality of wheels affects the stability and performance of the truck.
Uneven wear reduces truck stability and increases the stopping distance.
u After replacing wheels, make sure the truck is not skewed.
u
Always replace wheels in pairs, i.e. left and right at the same time.
Z
When replacing wheels fitted at the factory, only use the manufacturer’s original
spare parts. Otherwise the truck's rated performance cannot be ensured, see
page 121.
124
10.19 en-GB