Jungheinrich EJE KmS 16, Operating Instructions Manual

Page: 19 / 45

020
1.G
B
D 4
5 Removing and installing the battery
– Expose the battery (refer to section 3).
– Push the battery against the frame in
order to relieve the battery support (5).
Raise the battery support
– by the eyes,
– push it a little distance into the chas-
sis,
– lift and withdraw it.
f
Batteries with open poles, or open cell
bridges, must be covered with a rubber
mat to prevent short-circuiting. When us-
ing a crane in battery replacing opera-
tions, ensure that the crane is of
adequate capacity (refer to the battery
weight indicated on the battery identifi-
cation plate located at the battery trough). The battery must be lifted vertically to pre-
vent crushing of the battery trough. Lifting hooks must be applied in such a way that,
with the lifting gear slack, they will not drop on to the battery cells.
– Secure the lifting gear.
– Lift out the battery.
f
When replacing batteries, ensure that a battery of the same type is fitted. Additional
weights must not be removed and their position must not be changed.
– Installation is in the reverse order of operations.
f
Following reinstallation of the battery, visually check all leads and connectors for
damage and prior to the recommissioning of the truck check
– that the battery support is locked and
– that the battery hood is safely locked.
5
5
020
1.G
B
D 4
5 Removing and installing the battery
– Expose the battery (refer to section 3).
– Push the battery against the frame in
order to relieve the battery support (5).
Raise the battery support
– by the eyes,
– push it a little distance into the chas-
sis,
– lift and withdraw it.
f
Batteries with open poles, or open cell
bridges, must be covered with a rubber
mat to prevent short-circuiting. When us-
ing a crane in battery replacing opera-
tions, ensure that the crane is of
adequate capacity (refer to the battery
weight indicated on the battery identifi-
cation plate located at the battery trough). The battery must be lifted vertically to pre-
vent crushing of the battery trough. Lifting hooks must be applied in such a way that,
with the lifting gear slack, they will not drop on to the battery cells.
– Secure the lifting gear.
– Lift out the battery.
f
When replacing batteries, ensure that a battery of the same type is fitted. Additional
weights must not be removed and their position must not be changed.
– Installation is in the reverse order of operations.
f
Following reinstallation of the battery, visually check all leads and connectors for
damage and prior to the recommissioning of the truck check
– that the battery support is locked and
– that the battery hood is safely locked.
5
5