Jungheinrich EJE 220, Operating Instructions Manual

Page: 119 / 232

7.3.10 Setting the automatic truck cutout (timeframe)
Requirements
– To prepare the truck for operation, see page 108.
Procedure
• Press the O key (69).
• Enter the valid master code with the digit keys.
When you enter the correct master code the LED
(68) flashes green.
• Enter the 0-1-0 parameter with the digit keys.
• Confirm with the SET key (67).
Wait until the LED (68) flashes green.
• Set the truck automatic cutout (time period) with the digit keys:
• 00:
Automatic truck cutout is deactivated.
• 01 - 30:
Set time period (in minutes) after which the truck automatically cuts out
(minimum cutout time is 1 minute,
maximum cutout time is 30 minutes).
• 31:
After 10 seconds the truck cuts out automatically.
• Confirm with the SET key (67).
Wait until the LED (68) flashes green. The setting is saved.
• Press the O key (69).
The truck is switched off and the LED (68) lights up red.
• Checking the truck's automatic cutout:
• Switch on the truck with a valid operator code, see page 108.
When you have entered a valid operator code the LED (68) lights up green, the
travel program selected is indicated by the corresponding LEDs (64,65,66) and
the truck is switched on.
• Do not perform any travel, steering or hydraulic operations with the truck.
• Wait until the truck automatically cuts out at the end of the time period.
The truck is switched off and the LED (68) lights up red.
67
64 65 66
69 68
119
04.19 en-GB