o
Mark the installation location using the enclosed template. Install the concealed appliance
box, anchor holes for screw fastening Ø = 6 mm.
o
Slacken the fastening screws (4) with the enclosed tool – two-hole spanner bit SP-4 – and
remove the front plate (6).
o
Slacken the lid screws (10) on the connection box (8) and remove the lid (9).
o
Run the connecting cables through the openings (11) of the connection box.
o
Connect the bus wires with the red and black bus terminal to the bus connection (13).
o
Connect the power supply with the yellow and white terminal to the connection (12).
i
The second wire pair of the bus cable can be used to provide the power supply.
o
Close the lid (9).
i
The physical address must be noted on the device. If possible load the physical address
into the device before final mounting (see chapter 5.2. Commissioning).
o
Place the device in the concealed box and screw it to the substrate. Use the enclosed
screw/anchor set (7).
o
Push the written push-in labels into the top of the intended slots on the rear side of the front
plate.
o
Attach the front plate. Insert the screw sleeves (5) and fasten them to the housing using the
fastening screws (4). Max. torque: 0.5 Nm.
5.2 Commissioning
Loading the physical address and application software
The device is connected and ready for operation.
The power supply and bus voltage are switched on.
o
Press the top left and right sensor areas simultaneously.
The programming LED on the right edge of the panel (3) lights up.
o
Assign physical address.
The programming LED goes out.
o
Load the application software into the device.
o
Note the physical address on the labels on the rear side of the device and behind the front
plate.
Checking the LED function
The device is connected and ready for operation.
o
Press the top left and bottom right sensor areas simultaneously.
All the LEDS light up in sequence for 2 seconds each in red, green and blue.
6 Appendix
6.1 Technical data
External supply
Rated voltage
AC/DC 24 V SELV
Rated frequency
50 / 60 Hz
Power consumption
max. 2.2 W
Connection of power supply
Connection terminal
Single stranded
0.6 ... 0.8 mm²
Front plate
Dimensions W×H×D
approx. 236x156x14 mm
Installation depth
approx. 39 mm
Push-in labels
Dimensions L×W
approx. 132×39.5 mm
Ambient conditions
Ambient temperature
-20 ... +70 °C
Storage/transport temperature
-20 ... +75 °C
5/7
82575503
J:0082575503
07.12.2010
Signal panel
