Maintain a distance of at least 1 m between transmitter and receiver in order to prevent
overmodulation of the receiver.
Figure 3
o
Connect the switch actuator (1) and if necessary the installation button (5) in accordance
with the connection diagram (figure 3).
i
Lay the antenna stretched out freely if possible.
o
Fitting the switch actuator.
o
Switch on mains voltage.
i
The load can be switched on or off by pressing the programming button briefly (for about
1 second).
5.2 Commissioning
i
Observe the instructions for the radio transmitter.
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, cover up live parts in the working environment.
Teaching a radio transmitter
i
If all memory slots are occupied, a radio transmitter which has already been taught must
first be deleted. To do this, delete all taught channels and light scenes of the radio
transmitter individually.
The distance between the receiver and the radio transmitter is from 0.5 m to 5 m.
Load is switched off.
o
Press the programming button of the switch actuator or the installation button for approx. 4
seconds.
i
When the installation button is pressed the load is switched on for a duration of approx.
4 seconds.
The LED blinks. The device is in programming mode for approx. 1 minute.
o
Trigger teach telegram on radio transmitter (see instructions for radio transmitter).
LED lights up. The radio transmitter has been taught.
o
Press the programming button of the actuator or the installation button briefly.
Light switches on. The actuator is in operating mode.
3/5
82526923
J0082526923
09.09.2016
Radio Management
Radio switch actuator, built-in
