DANGER!
Danger of electrical shock!
When mounting with 230 V socket outlets under a common cover there is a
danger of electrical shocks in the event of a fault!
Use only the enclosed plastic screws for fastening to the supporting frame.
o
Mount supporting frame (1) in the correct orientation on an appliance box. Note marking
TOP
; marking
A
or
B
in front. Use only the enclosed box screws.
o
Push frame (2) onto supporting frame.
o
Connect push-button module (4) to the KNX using KNX connecting terminal (7) and push
onto the supporting frame.
o
Fix pushbutton module to supporting frame using the enclosed plastic screws (5). Tighten
the plastic screws only lightly.
o
Before mounting the buttons (6), load the physical address into the device (see chapter
4.2. Commissioning).
4.2 Commissioning
Loading the physical address and application software
Configuration and commissioning with ETS3.0d Patch A or more recent.
The device is connected and ready for operation.
The buttons are not mounted yet.
i
If the device does not receive any application software, or the wrong application software,
then the blue operation LED flashes slowly.
picture 2: Activating programming mode
o
Activate programming mode: Press and hold push-button at the upper left (9). Then press
push-button at the lower right (10, 11 or 12):
Push-button module
Prog. push-button
– 4gang, 3gang
(9) + (10)
– 2gang
(9) + (11)
– 1gang
(9) + (12)
The operation LED (13) flashes quickly.
o
Load physical address into the device.
3/5
32566613
J:0082566613
24.11.2009
Standard push-button module with integrated BCU
