Page 7
0024015020 12.10.2012
Assigned status LEDs light up.
• Set the LEDs by pressing the button next to the respective LED.
The LED switches on/off.
Switching the blue orientation light on/off.
• Press 9 button.
Blue LED switches on/off
All LEDs have been set
• Back to programming level: press and hold button 16 approx. 3 seconds.
LEDs 1 - 4 light up.
• End programming level: press and hold button 16.
Operating level is active.
Button 6: Stations
Before light scenes are set, which station is connected with which device address must be entered here.
ⓘ
The push-button sensor module recognises whether one or two stations are connected. When one station is connected, only LED 1 lights
up.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Bild 8: Relay station presetting
Presetting:
Relay station to device addresses 1 and 2
Relay station Dimming
station
Device address
1
Button 1
LED 1
Button 2
LED 2
Device address
2
Button 5
LED 3
Button 6
LED 4
• Press button 6 (
stations
).
The mode
Stations
is active.
• To set the stations, press buttons as indicated in the table.
Example:
Device address 1 dimming station:
button 2
Device address 2 relay station:
button 5
• Back to programming level: press and hold button 16 approx. 3 seconds.
LEDs 1 - 6 light up.
• End programming level: press and hold button 16.
Operating level is active.
Reset
Reset push-button sensor module to the state as delivered. All settings are overwritten.
The push-button sensor module is in normal mode.
• Press micro buttons 12 – 9 – 7 – 9 in sequence.
All LEDs flash 2x
• Press micro buttons 12 – 9 – 7 – 9 in sequence once again
All LEDs flash 2x
The state as delivered has been restored.
Push-button sensor module is ready for operation.
Installing buttons
• The buttons are available as a complete button set. Individual buttons or the complete button set can be replaced using buttons with sym-
bols.
ⓘ
The installation spider is not necessary to install the buttons.
ⓘ
Place buttons on the device in the right orientation and push briefly to snap in.
Observe the label TOP.
ⓘ
Laser-print buttons at www.jung-lasern.de
Cloning push-button sensor modules
„Cloning“ means transmitting the button assignment of a push-button sensor module to other push-button sensor modules. No operation of the
stations is possible during an ongoing cloning operation. Only push-button sensor modules with the same release status can be cloned with
each other.
Several push-button sensor modules are connected to the station.
Press the MODE and Central Switching Mode buttons of the relay station or the MODE and Prog. button of the dimming station simultane-
ously until the LEDs , ON/▲ and OFF/▼ flash. Stations and push-button sensor modules are in cloning mode.
All of the red LEDs on the push-button sensor modules are flashing.
• Press a button on the push-button sensor module being cloned within approx. 2 minutes.
All of the red LEDs on the push-button sensor module flash rapidly.
All of the red LEDs on all of the other the push-button sensor modules continue to flash.
• Press a button on another push-button sensor module within approx. 2 minutes.
