Page 4
0024015020 12.10.2012
Preliminary remark to programming
The program is called up by entering a 4-digit button combination twice. LEDs 1 - 4 + 6 light up.
Preliminary remark to grouping (button 1)
The push-button sensor module can be operated with 1gang, 2gang, 3gang and 4gang button sets. The push-button sensor module and the
push-button sensor expansion module have to be re-grouped depending on the cover and the channels being switched.
Assignment is performed without the cover.
Configuring the buttons
Each button can be configured for its entire surface or divided top/bottom. This is done by assigning the buttons as follows.
For example configuration, see Figure 4.
1gang button
Entire surface:
Press micro button 1 and then 16.
Top/bottom:
Top: press micro button 1 and then 4
Bottom: press micro button 13 and then 16
2gang button
Entire surface, left
Press micro button 1 and then 14.
Entire surface, right
Press micro button 3 and then 16.
Top/bottom left:
Top: press micro button 1 and then 2
Bottom: Press micro button 13 and then 14
etc.
Assigning the relay or dimming station outputs to the buttons on the push-button module.
• Relay station: toggle mode. The output is switched on or off through the same button. In blind/shutter mode, one channel for moving up and
one channel for moving down are assigned.
• Dimming station: 2 channels are assigned to each output. Example output 1: channel 1 switches on and dims brighter, channel 2 switches
off and dims darker.
Preliminary remark to central function (button 2)
Central OFF and central ON can be assigned independently of each other.
Channels which should respond to the central function are set at the stations. In the state as delivered, all channels respond to the central
function.
Preliminary remark to light scene (button 3)
ⓘ
Before setting the light scene, the station must be set through button 6.
Switching several outputs with one button.
Switching states are assigned to the outputs.
4 light scenes per control point are available.
Preliminary remark to status LED on/off (button 4)
The button next to the respective LED switches the LED on or off.
When switched on, the LED indicates the status of the channel.
Switched-off LEDs are always off.
The blue orientation light is switched on/off through button 9.
Preliminary remark to stations (button 6)
Setting which stations, relay or dimming station, are connected.
Programming mode from state as delivered or after reset
No change on the push-button sensor module has taken place yet.
When grouping, central function or light scene are selected, all pre-set assignments are deleted. All surfaces can be reassigned.
When status LED on/off is selected, the preset links are retained even when no changes have been made and the area is left directly through
button 16. Existing links are retained and can be changed.
Changing the links
A push-button sensor module which no longer corresponds to the state as delivered can be changed to the respective mode. Links and settings
are retained.
Programming
Entering a 4-digit button combination brings you to the programming level.
The push-button sensor module must be connected to the station.
Programming level
No switching commands are executed in the assignment mode.
Cover is not installed.
• Press buttons 6 – 3 – 5 – 5 in sequence (Figure 5).
All LEDs flash 2x
• Press buttons 6 – 3 – 5 – 5 in sequence once again.
All LEDs flash 2x.
LEDs 1 - 4 + 6 light up.
The selection level is active.
Button 1: grouping
Button 2: central function
Button 3: light scene
Button 4: status LED on/off
Button 6: stations
