Connecting and mounting the device
picture 1
(1) Supporting ring
(2) Box screws
(3) Design frame
(4) Button sensor module
(5) Plastic screws
(6) Covers
(7) KNX connection terminal
Supporting ring side
A
for switch design range FD-Design, Supporting ring side
B
for LS design
range.
Button sensor module 8-fang (picture 2): When mounting on only one flush-mounted socket,
countersink the lower screws into the wall, e.g. with ø 6 x10 mm hole. Use supporting ring as
template.
Button sensor module with illuminable text field: Fasten with only one plastic screw. If possible
label before assembly (see chapter 4.2. Commissioning).
DANGER!
Danger of electrical shock!
When mounting with 230 V socket outlets under a common cover there is a
danger of electrical shocks in the event of a fault!
Use only the supplied plastic screws for fastening to the supporting ring.
o
Mount supporting ring (1) in the right orientation on an appliance box. Use only the
supplied box screws (2). Note marking
TOP
; marking
A
or
B
in front.
o
Push frame (3) onto supporting ring.
o
Connect button sensor module (4) to the KNX using KNX connecting terminal (7) and push
onto the supporting ring.
o
Fix push-button module to supporting ring using the supplied plastic screws (5). Tighten the
plastic screws only lightly.
o
Before mounting the control surfaces (6), load the physical address into the device (see
chapter 4.2. Commissioning).
3/7
32558813
J:0082558813
19.06.2009
Push-button module with integrated BCU Standard / Universal
