Jung Pumpen compli 300, Instruction Manual

Page: 3 / 6

3
Application
The compli 300 lifting station is manufactured in accordance
with DIN EN 12050-1 and is approved for the disposal of was -
tewater from toilets and urinals, and domestic wastewater con -
taining the usual impurities (as defined in Part 3 of DIN 1986).
The sewage lifting station can withstand submersion.
Submersion depth: 2 m of water; submersion period: 7 days.
The control unit cannot withstand submersion, but is splash-
proof in accordance with IP 44.
Scope of supply
• Sewage lifting station with DN 100 inlet with clamp flange
• Flexible connection with hose clamps for the pressure pipe
• Slip-on socket pipe, DN 80, for ventilation pipe
• Plug-in seals for connection of diaphragm hand pump and
inlet at the side
• Fixing materials for tank
• Connection flange for pressure pipe, DN 80
• Non-return valve, DN 80, for the pressure pipe
Jung Pumpen GmbH • Industriestr. 4-6 • 33803 Steinhagen
XX1
DIN EN 12050-1
Sewage lifting station for buildings, DN 80
See technical data for pumping capacity
Noise emission < 70 dB(A)
1 The first two digits of the pump number indicate the year of production
Electrical connection
Only qualified electricians may carry out electrical
works to the pump or the plug.
The relevant standards (such as EN standards), country-specific
regulations (such as VDE in Germany), and the regulations of
the local power supply companies must be observed.
Never put the mains plug in water! If water gets into
the plug, this can cause malfunctions and damage.
Observe the operating voltage (see the type plate)!
Only connect the pump to sockets that have been installed
properly in accordance with the regulations and are fitted with
at least a 10 A (delay) fuse. No additional motor protection is
required, since the system has an integrated coil thermostat.
Unacceptably high temperatures and long periods of conti -
nuous operation cause the thermostat to shut down the motor.
After the thermostat has switched off the system, pull out the
mains plug before remedying the fault, since the device can
switch itself on again automatically if the power is still connec -
ted.
The control unit
The compli 300 has a level controller that switches the pump
on and off depending on the level of the water. An integrated
alarm system beeps if there is a malfunction, even if this is only
temporary. In the connector on the circuit board, there is a po -
tential-free fault indicator contact (5 A/250 V) at terminals 40
and 41, which allows the alarm signal to be relayed if required.