ESTIMATED AC RECHARGE TIMES TO REACH FULL CHARGE
After a single jump start:
2 hours
After multiple jump starts:
12 hours or overnight
After using as portable power:
24-36 hours
Charging using the supplied 12 Volt Male-Male Extension Cord. This alternative charging
method may be used when access to an AC outlet is unavailable. (Overcharge Risk -
See below)
1. Start the vehicle’s engine.
2. Plug one end of the 12 Volt Male-Male Extension Cord into the Jump-N-Carry
12 Volt outlet and the other end into the vehicle’s 12 Volt power port.
3. Charge the unit based on the suggested recharge times shown in the following
table.
SUGGESTED 12 VOLT RECHARGE TIMES
After jump starting:
20 minutes
After using as portable power:
2 hours (Monitor frequently)
After high discharge conditions:
4 hours (Monitor frequently)
Note: DO NOT OVERCHARGE! You must frequently monitor the 12V charging process
to ensure the unit is not overcharged. Overcharging will damage your Jump-N-Carry.
Jump Starting Instructions
Note: For optimum performance, do not store your Jump-N-Carry below 50°F when
using as a jump starter. NEVER charge or jump start a frozen battery.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eye wear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Turn ignition off before making cable connections.
5. Clamp the positive (red +) clamp to the positive terminal on the vehicle
battery (for negative ground system), or an alternate vehicle starting point as
recommended by vehicle manufacturer.
6. Clamp the negative (black –) clamp to the vehicle ground (non-moving metal part,
such as the vehicle frame).
7. Make sure the cables are not in the path of moving engine parts (belts, fans,
etc.).
8. Stay clear of batteries while jump starting.
9. Start the vehicle (turn on the vehicle ignition).
Note: If the vehicle doesn’t start within 6 seconds, let the Jump-N-Carry cool
for 3 minutes before attempting to start the vehicle again or you may damage the
Jump-N-Carry.
10. When the vehicle is started, disconnect the negative (–) battery clamp from the
vehicle frame and return it to its holster.
11. Disconnect the positive (+) clamp and return it to its holster.
