- 5 -
OPERATION AND STORAGE
TO TURN ON THE HEATER
1. Turn on the valve on the gas cylinder.
2. Press and turn the control knob to HI position
(anti-clockwise 90° ).
3. Press and hold down the control knob, at the same time
repeatedly pressing the igniter button until the burner is ignited.
Release the control knob 10 seconds after the ignition, at which
time the burner should remain alight.
4. Turn the control knob to LO and leave it there for
5 minutes or more before turning the knob to the
desired temperature setting.
5. If the burner fails to light or goes out turn the control knob to
the "OFF" position. Wait at least 5 minutes to allow any gas
to dissipate, and repeat steps 2 - 4.
6. If still unable to light the burner turn the control knob to the "OFF"
position, turn off the valve on the gas cylinder, disconnect and
remove the gas cylinder and return the heater to the place of
purchase for a replacement.
TO TURN OFF THE HEATER
1. Turn the control knob to HI position.
2. Press and turn the control knob to OFF position.
3. Turn off the valve on the gas cylinder.
Storage
1. Always close the gas valve of the gas cylinder after use or in case of a disturbance.
2. Disconnect the regulator from the gas cylinder valve.
3. Check the tightness of the gas valve for damage. If you suspect damage, have it changed
by your gas dealer.
4. Never store liquid gas cylinder in a sub-terrain, or at places without adequate air ventilation.
5. There is no limitation on the storage of appliances indoors provided that the cylinder is removed
from the appliance; and
6. Storage of an appliance indoors with the cylinder attached is only permitted if the size of the
cylinder complies with AS/NZS 1596; otherwise cylinders must be stored outdoors in a
well-ventilated area and out of reach of children.
Summary of Contents for JDS06
Page 5: ...610mm 460mm...