ENGLISH
102
C.
Setting the duration of the alarm
With the Smart Panel’s factory setting, the alarm lasts for one minute after being triggered. The duration
of the alarm can be increased to up to six minutes if required.
Buttons
Description
Note
1 (1234/4-
digit PIN
code)
+
You must be in standby
mode before you can
set the alarm’s duration.
* How to check you are in standby mode:
Key in the factory-set PIN code 1 2 3 4 or your new 4-
digit PIN code.
Press .
The following appears on the Smart Panel when in
standby mode.
(One beep indicates that you have entered a valid PIN code.
Three beeps indicate that you have entered an incorrect
code.)
2 (1234/4-
digit PIN
code)
+
Key in the factory-set
PIN code 1 2 3 4 or
your new 4-digit PIN
code followed by
.
The following appears on the Smart Panel:
3
+
Press
and then
(as many times as
required) to set the new
alarm duration.
The first time
is pressed, the number of minutes
for the current duration flashes on the Smart Panel (the
factory setting is 1 minute).
Every
time is pressed, the alarm’s duration is
increased by one minute, up to the maximum duration
of 6 minutes.
The length of the duration flashes on the display until
setting is completed.
4
Press
to complete
the setting.
Confirm the setting and reset the Smart Panel to standby
mode by pressing
.
D.
Deactivating audible countdown
When the Smart Panel is armed, the audible countdown (the buzzer) can be silenced by pressing and
holding the silent button (crossed-out speaker) during the countdown. The audible countdown (the
buzzer) is activated again by pressing the silent button again.