Jula Meec tools 005876, Operating Instructions Manual

Page: 29 / 33

EN
29
• Switch off the appliance, pull out the plug,
and wait until all moving parts have
completely stopped before moving away,
before transporting the appliance, before
cleaning the rotor housing or ejector, and
before cleaning, inspection, adjusting or
repairing.
• Be very careful when changing direction
on slopes.
• Be careful when reversing with the
appliance.
• Never use the appliance if the guards or
safety devices are dismantled or
damaged.
• Never point the ejector at people or
animals, or at objects that can be
damaged. Keep onlookers, especially
children, and pets at a safe distance.
• Do not overload the appliance by trying to
remove too much snow too quickly.
• Never use the appliance in poor visibility
or bad light. Make sure you always have a
firm footing and a firm grip on the
handle. Never run with the appliance.
• Never use the appliance near cars, or
windows, etc.
CLEARING THE ROTOR HOUSING
Follow the instructions below to clear the rotor
housing:
– Switch off the appliance and pull out
the plug.
– Wait 10 seconds to make sure that
the snow screw has completely
stopped.
– Use a suitable tool to clear the rotor
housing and/or release the snow
screw. Never use your hands.
WARNING!
Never clear the rotor housing with your hands.
If your hands or feet come into contact with the
snow screw there is a risk of serious personal
injury.
MAINTENANCE AND STORAGE
• Check at regular intervals that all unions
are intact and properly tightened, and
that the appliance is in safe working
condition.
• Follow all the instructions and safety
instructions, including the storage
instructions.
• Stickers with safety information and
instructions must always be clean and
legible. Replace them if necessary.
• When not in use, store the appliance in a
dry place out of the reach of children.
ELECTRICAL SAFETY
• Only connect the appliance to a fused and
RCD protected power point.
• Only use an extension cord approved for
outdoor use.
• Never modify the plug in any way. Allow
an authorised electrician to install an
earthed power point if the plug does not
fit in the power point.
• Check that the extension cord is in good
condition. The wire cross-sectional area of
the extension cord must be dimensioned
for the power supply to the appliance. An
extension cord with a length of up to 15
metres should have a minimum wire
cross-sectional area of 1.5 mm². An
extension cord with a length of up to 30
metres should have a minimum wire
cross-sectional area of 2.5 mm². An
undersized extension cord causes a
voltage drop, which leads to power loss
and overheating.
WARNING!
• An electric shock can cause serious
personal injury and/or death.
• Make sure that no part of appliance
comes into contact with water or any
other liquid when it is use. If the
appliance has got wet, wipe it dry before
use.