EN
22
INSTALLATION
• Use the exploded view for installation.
• Lay out all the parts in front of your before starting the installation.
USE
The workshop press is intended for straightening, eccentric pressing, die pressing and forming,
for example crankshafts, connecting rods, and for press fitting of axles, gears and bushings.
WARNING: Read, understand and apply the safety instructions and warnings before use.
BEFORE USING FOR THE FIRST TIME
• Before using the workshop press for the first time the hydraulic system must be bled.
– Open the valve by turning it anticlockwise.
– Pump several times to remove all the air from the system.
• Check all the parts. Do not use the workshop press and contact the supplier if any part is
defective.
HOW TO USE
1.
Place the intermediate plate on the press platform and position the workpiece on the plate.
2.
Close the valve by turning it clockwise.
3.
Pump with the handle until the knurled saddle comes to the workpiece.
4.
Align the workpiece and hydraulic cylinder so that the pressure comes in the middle.
5.
Pump with the handle to press the workpiece.
6.
Stop pumping when the pressing is done. Release the pressure from the workpiece by
carefully turning the valve anticlockwise in small steps.
Summary of Contents for HAMRON 619550
Page 3: ......