ENGLISH
18
How to use
Rinse your mouth with water before using. Avoid smoking or drinking alcohol for at least 10 minutes
before using. For a more reliable result you should always take 2 measurements one after the other.
1.
Insert a nozzle and press the ON/OFF button for 1 second to start the appliance. ALCO is shown in
the display when the appliance starts. Press the ST button to activate the warming of the sensor.
PH flashes 3 times and the countdown from PH99 to PH00 starts. READY and BLOW flash
alternately when the appliance is ready for use, and audio signals are heard while the time is
counted down from 30 to 0 seconds.
2.
Press and hold the ST button and blow smoothly through the nozzle for about 6 seconds. An audio
signal is heard when the measurement is ready. Stop blowing when you hear the audio signal. If
the measurement has been successful ANLY will flash while the analysis is made, after which the
reading is shown.
3.
Press the ST button to measure again. The appliance is ready for the next measurement when the
countdown reaches 0, whereby READY is shown in the display and you hear the audio signals.
4.
The reading is shown in the display within 10 seconds.
Press