ENGLISH
8
ENGLI SH
SAFETY INSTRUCTIONS
Read these instructions carefully before use!
Disconnect the mains voltage before starting installation.
The bulb gets very hot when it is switched on. Wait until it has cooled before touching it. Do not
touch bulbs with your bare hands.
Do not use the lamp without the entire lamp shade in place.
Be careful not to exceed the stated rated output of the bulb (60 W).
The lamp must be connected to a properly earthed power outlet.
The power cord must be type H05RN-F 3G, 1 mm
2
, or stronger.
Install a double pole switch.
WARNING:
Do not use the lamp post if the power cord and/or plug are damaged in any way. For safety
reasons, the power cord must only be replaced or repaired by an authorised service centre.
Consult your dealer.
TECHNICAL DATA
Mains voltage
220
– 230 V/50 Hz
Rated output
Max. 60 watts
Safety class
I
Protection rating
IP44
Base
E27
DESCRIPTION
Component
Qty
Component
Qty
A: Triangular support
1
I1: Washer for bolt M10
3
B: Anchor rod/bolts
3
I2: Screws M6 x 16
3
C: Base
1
I3: Screws M5 x 10
3
D: Lower post unit
1
I4: Screws M5 x 5
3
E: Upper post unit
1
Terminal block (not supplied)
1
F: Lamp
1
Hex key for M3
1
Hex key for M4
1
Spring washer under M10
3
External mains wires
Internal
mains
wires