Jula 242-160, Operating Instructions Manual, Page: 33 / 36

ENGLISH
33
Mitre sawing

Secure the workpiece with the screw clamp.

Loosen the locking lever and set the required cutting angle. Tighten the locking lever again.

Make sure the cleaver blade is in line with the saw blade.

Start the saw and feed the workpiece at a gentle rate (fig. 21).

Always hold the workpiece securely.

Allow the saw blade to stop before removing the workpiece.
Angle cutting

Place the angle fence in one of the two slots on the worktable. Set the required angle.

Start the saw and feed the angle fence with the workpiece towards the saw blade.

Allow the saw blade to stop before removing the workpiece.

Always hold the workpiece securely (fig. 22).
21 22
Setting the cleaver blade

Remove the screw O holding the cleaver
blade (fig. 23).

Place the cleaver blade in the required
position.

Retighten the screw.
23
Max. cutting depth
The distance between the workbench and cleaver blade’s upper section is 10 cm.
Setting the cleaver blade

Remove the screw O holding the cleaver blade (fig. 23).

Place the cleaver blade in the required position.

Retighten the screw.
Dovetailing

The cleaver blade must be 2 mm below the top of the saw teeth. The distance between the cleaver
knife and blade must be 3-8 mm.

Place the parallel fence at the required distance from the saw blade in one of the slots on the
worktable.

Hold the workpiece securely. Avoid putting your hands close to the saw blade.

Allow the saw blade to stop before removing the workpiece.
Dust extractor
If the saw is used indoors a chip/dust extractor must be fitted. The dust bag is attached at the marking (J)
(fig. 24 and 25).