ENGLISH
32
10 11 12
12.
Activate the depth stop using the lever (H) (fig. 13). The depth stop must be deactivated when the
saw is used as bench ripsaw.
13. Loosen the wing nut (N) and change the position of the cleaver blade (fig. 14). The cleaver blade
must now be positioned parallel to the upper blade guard (fig. 15).
13 14 15
14.
Tighten the height adjustment screw (I) (fig. 16).
15. Fit the chip extractor (J) on the underside of the worktable (fig. 17). The chip extractor should be
pushed into the two cut-outs and secured with a screw (K) (fig. 18).
16 17 18
16. The saw can be tilted 0-45
by loosening the locking lever (H) (fig. 19). The angle of the saw can
also be changed by loosening the lock knob (J) (fig. 20).
19
20
Starting
Start the saw by pressing the green power switch. Turn off the saw by pressing the red power switch
marked 0. There is also an emergency stop button, for use in emergencies.
Straight cutting
Set the parallel fence to the required width. Place the workpiece on the worktable and feed it at an even
rate towards the blade. Keep your hands and fingers away from the saw blade. Use the pusher when
necessary.
Summary of Contents for 242-160
Page 36: ......
