– 154 –
3) Connecting the cords
1. Pass cords
❶
and
of the thread-trimming
solenoid, reverse feed stitching, motor signal
etc. and the motor cord through the hole
A
in
the table to route them to the underside of the
table.
2. Loosen screw
B
in cover
❷
with a screwdriver
to open the cover
❷
.
[Connecting the connector for the operation panel]
3. Insert 14P code
❸
coming from the
machine head into connector
❻
(CN36).
4. Insert 3P cord
❾
coming from the
machine head into connector
(CN42).
5. Insert presser foot lifter cord 2P
❹
into connector
❼
(CN37).
6. Connect 9P connector
❺
coming
from the motor to connector
❽
(CN30) on the circuit board.
7. Insert pedal sensor cable
into connector
(CN34).
8. Insert motor fan cord
into connector
(CN55).
9. Insert 8P cord
into connector
(CN56).
(Caution) Be sure to securely insert the respective connectors after checking the inserting directions
since all connectors have the inserting directions. (When using a type with lock, insert the
connectors until they go to the lock.) The sewing machine is not actuated unless the con-
nectors are inserted properly. In addition, not only the problem of error warning or the like
occurs, but also the sewing machine and the control box are damaged.
The connector for the operation panel is provided.
Paying attention to the orientation of the connector
, connect it to connector
(CN38) located on the
circuit board. After the insertion, securely lock the
connectors to prevent them from coming off easily.
(Caution) Be sure to turn OFF the power before
connecting the connector.
❷
B
❼
❹
❺
❽
❸
❻
❾
❶
A
