JUKI MB-1373, Instruction Manual

Page: 7 / 18

– 5 –
3-4. adjusting the nipper
0.4 to 0.6 mm
1
2
1) Provde a 0.4 to 0.6 mm clearance
between npper block
2
and npper
1
to prevent the npper
1
from hold-
ng the thread whle the machne s n
operaton.
2) Loosen screw
3
and move npper bar
block
4
to the rght or the left.
3-5. adjusting the thread tension guide on the face plate
★
adjust the needle-to-looper relation as follows :
1) Depress the pedal fully forward, turn the needle drvng pulley n the normal sewng drecton by hand to
brng down the needle bar to the lowest poston of ts stroke and loosen screw
1
.
WarnInG :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
WarnInG :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
3-6. needle-to-looper relation
If the formaton of seams at the start of sewng s
faled and the seams are formed on the way even
when the thread pull-off lever s adjusted, turn thumb
nut
1
(double nut) to decrease the thread tenson.
1
2
2
3
A
B
C
5
4
6
2
tQx1
tQx7
4
3
(adjusting the needle bar height)
2) Adjust the heght of the needle bar usng the top
two lnes engraved on the needle bar
2
for the
TQx1 needle and usng the bottom two lnes for
the TQx7 needle. Algn the upper lne
A
wth the
bottom end face of needle bar bushng (lower)
3
and tghten screw
1
. At ths tme, tghten the
screw so that groove
C
of the needle faces the
front.
(looper position)
3) Loosen screws
4
and turn by hand the needle drv-
ng pulley untl lower lne
B
of two lnes algns wth
the bottom end face of needle bar bushng (lower)
3
.
4) By keepng the machne n ths state, algn looper blade
5
wth the center of the needle and tghten screws
4
.
5) Loosen screws
6
and provde a 0.01 to 0.1 mm
clearance between the looper and the needle.
Tghten screws
6
.
1