– 9 –
3-15. automatic thread trimmer
(1) adjusting the position of the moving knife
When the presser has completely lfted at the stop-
moton poston (
refer to
"3-14. adjusting the posi-
tion of the stop-motion", p.8
), t s the standard
that the clearance between thread trmmng con-
nectng plate (front)
1
and the end face of the slt of
throat plate
2
s 10 to 11 mm. To adjust the afore-
mentoned clearance, tlt the machne head, remove
the ol sheld, loosen two nuts
3
and move connect-
ng screw
4
back or forth. When you tghten nuts
3
,
ensure that jont
5
stays n the horzontal poston.
3-16. clearance between the button clamp lifting lever and the adjusting screw
Provde a 0.5 mm clearance between the end face of
button clamp lftng lever
1
and adjustng screw
2
at the stop-moton poston (
refer to "3-14 adjusting
the position of the stop-motion", p.8
) and tghten
wth adjustng screw nut
3
.
3-17. How to set the l-shaped lifting rod
Put movng knfe push-back sprng
2
, stop-moton
rubber cushon washer
3
, stop-moton rubber cush-
on
4
and stop-moton rubber cushon washer
5
, n
ths order, to L-shaped lftng rod
1
. Make the jaw
of the machne arm come nto close contact wth the
end face of the stop-moton rubber cushon washer
at the stop-moton poston (
refer to "3-14 adjust-
ing the position of the stop-motion", p.8
) and set
the L-shaped lftng rod wthout a play. Then tghten t
wth screw
6
.
WarnInG :
to protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
2
3
0.5 mm
1
2
5
4
3
6
1
1
2
5
4
3
10 to 11 mm
Summary of Contents for MB-1373
Page 1: ...ENGLISH Instruction Manual...
