KE2000 Installation Manual
44
16.
Adjusting the height of the overall feeder exchange trolley
(optional)
Always adjust the height of the overall feeder exchange trolley after the machine has been
leveled correctly.
<CAUTION>
Do not fall down the replacement table while changing the caster plate mounting position.
Doing so may cause the trolley handle to break.
16-1. Caster plate mounting position
A 2-step height adjustment is
provided
on the overall feeder
exchange trolley.
The height of the overall feeder
exchange trolley is adjusted by
changing the caster plate
mounting position so that it
meets
the board transport
height.
Table 16-1-1
Transport height
Caster plate
mounting position
880
〜
900
Upper
900
〜
920
Lower
Unit: mm
Additionally, note that the caster plate
mounting position is located at the lower
portion when the overall feeder exchange
trolley is assembled to the machine.
<CAUTION>
As illustrated in the Figure shown to the right,
if the gap between the bank locate pin and the
lower face of the bank support is 7 mm or less,
it is necessary to change the caster plate
mounting position to the upper position.
Fig
１６－１－１
<CAUTION>
For overseas models, 50 mm
is added to the above height .
Trolley spacer
Trolley frame
Caster plate
Bank locate pin
Bank support
Fig
１６－１－２
