– 5 –
If the machine head comes down from its normal position due to aged deterioration, the folded edge of the material
and the seam (the edge) may not be properly aligned when placing the material position on the machine head.
In the case the smallest clearance (the difference in height) between the machine head bed and the feed section
is 0.7 mm or more, place spacers (0.5 mm and 1.0 mm) at locations
❶
,
❷
and
❸
to decrease the clearance (the
difference in height) to 0.7 mm or less
Feed plate
The lowest part of the feed block
0.5 to 0.7mm
Sewing machine bed
Clamp table
Spacer
Mfg. No.
a
b
Sub clamp catch plate
❶
Sub clamp catch plate
❹
Sub clamp catch plate
❺
When moving the device after you have
installed it in your plant, ground the device
referring to the dimensions given on the
attached sheet
2. ADJUSTING THE MACHINE HEAD
3. RECORDS OF ADJUSTED VALUES
❶
❷
❸
Spacer
a
b
