6
JUDO SPEEDY-LongLife
Intended use
2.1
Water pressure
The water pressure should be between
1.5 bar and 10 bar.
ATTENTION
(see chapter “Safety information and
dangers due to non-compliance”)
In the event of
water pressure above 10
bar
, the pressure reduction valve should be
fitted
in front
of the filter (see fig. 2). If the
operating pressure is above 10 bar, this may
result in defects during operation.
2.2
Notes on special dangers
2.2.1 Electrical equipment /
installations
Electrical devices / equipment that are not
splash-water proof and are situated in the
direct vicinity of the filter may be damaged
by water leaking from the filter caused as a
result of the device not being operated in
accordance with the manufacturer’s specifi-
cations. In addition this may also result short
circuits if these electrical devices / equip-
ment being connected to the electrical
power supply. In the event of such cases
persons are at risk and may sustain elec-
trical shocks. Therefore any electrical
devices / equipment situated in the direct
vicinity should be splash-water proof,
respectively comply with the statutory
requirements for wet areas (IP44).
Fig. 2:
Pressure reducer upstream of the unit
The installation of a pressure re-
duction valve is recommended for
water pressures between 5 bar
and 10 bar
.
1
1 = Pressure reducer
There must not be any electrical
cables and devices underneath or
in the immediate vicinity of the filter!
