Judo 8203525, Installation Manual

Page: 7 / 20

Installation
1 2
Fig. 1: Rotary flange fitting
1 Profile flange seal
2 Flow direction arrow
Initial state:
•
The three-way manifold and the three
bypass valves are pre-installed on the
frame and hygienically sealed with a
film.
•
The four hexagon socket head screws
and the profile flange seal are enclosed
loose in a bag.
•
The rotary flange fitting is enclosed in a
cardboard box forming part of the pack-
aging.
Installing the rotary flange fitting on the
three-way manifold (see Figure 2):
1.
Remove the black mounting cover on
the rotary flange fitting.
2. Remove the protective film on the inlet
side of the three-way manifold without
leaving any residues.
3. Fit the four hexagon socket head
screws and the profile flange seal on
the three-way manifold.
4. Push the rotary flange fitting onto the
hexagon socket head screws and
engage the bayonet.
INFO_NO_HEADER
The profiled side of the profile
flange seal must point towards
the rotary flange fitting (see
Figure 2).
5. Tighten the four hexagon socket head
screws.
UNIT
Select the tightening torque
(about 10 Nm) so that the profile
flange seal seals effectively.
The rotary flange fitting is now con-
nected to the three-way manifold.
Fig. 2: Installing the rotary flange fitting
on the three-way manifold
1 Frame
2 Bypass valves JQX
3 Thee-way manifold
4 Profile flange seal
5 Hexagon socket head screws
6 Rotary flange fitting JQE
3.3 Pipe up system and flush pipe
Initial condition:
•
The rotary flange fitting is installed on
the three-way manifold.
CAUTION
The rotary flange fitting must
be fitted so that it is free from
mechanical stress or strain. Oth-
erwise mechanical damage to the
pipe or the rotary flange fitting up
to and including breaks can result.
Creation of the system piping:
1.
Push the frame up to the wall.
2.
Align the frame so it is horizontal by
adjusting the four rubber feet.
3. Pipe up the system correctly.
1703525 • 2022/10 JUDO QUICKSOFT MEGA 6 7