www.modellmarkt24.ch
You can now locate the final long control horn and glue it into the slot on the
side of the rudder. This will be used for the rudder linkage that will be
constructed in the same way as the one used for the elevator. Once again, the
length for that linkage is 365mm. The guides for the rudder linkage will be
glued into the top of the vertical fuselage.
Locate the motor mount as shown above. Test fit the motor mount to the front
of the fuselage by bending the attached tabs 90 degrees and sliding it on
without glue. Once test fitted, place adhesive on the inside of the motor mount
covering every spot, then place again on the front of the fuselage making sure
everything is flush and lined up correctly.
www.modellmarkt24.ch