- 6 -
Field Configurators HARTConf, LHPConf for Transmitters with HART or LHP Communication and HART-USB Modem
4. Installation, operation and maintenance
4.1 Installation and commissioning
4.1.1 General
The instrument can be put into operation by installing a battery
and switch on according to the instructions in this manual.
During the battery installation, the right battery type in menu
Options | Battery Type must be properly selected.
4.1.2 Electrical connection
Connection of a transmitter with power supply from
the configurator
(set in menu: „Options | Power supply | Int./Ext. | Internal“)
Connection of a transmitter with power supply from
an external source
(set in menu: „Options | Power supply | Int./Ext. | External“)
4.1.3 Installation of a battery or accumulator into
the configurator HARTConf, LHPConf
In case of installation of a dry battery, make sure that “Battery
Type” is set to “Prim. Battery”! If not, set the configurator
correctly.
ATTENTION!
Using battery in the instrument when set to
“Accumulator” may cause damage to the battery by charging
it from USB!
In case you install a rechargeable accumulator, make sure
that “Battery Type” is set to “Accumulator”! If not, set the switch
correctly. This ensures correct charging when the instrument is
connected to USB.
4.1.4 Installation of USB driver
Correct work with a USB interface and charging through a USB
requires the necessary USB driver installed on the PC. Usually,
operating system search for a suitable driver after connecting
the configurator to the USB port. If this does not work, run „CDM
v2.10.00 WHQL Certified.exe“ file from the supplied CD. When
the driver is installed, the USB cable can be connected and the
required port number can be set in the Device Manager.
4.1.5 Charging of rechargeable accumulator
Charging is activated after connection of the USB cable to the
active port (port of running PC) or by connecting to the AC
adapter. A moving icon on the display indicates charging.
ATTENTION! Accumulator charging during activities of the
instrument is not possible when the internal supply source
for the transmitter is switched on. In case that it is necessary
to supply the transmitter and at the same time to charge the
accumulator, it is necessary to activate the battery saving
mode!
4.1.6 Instrument switch on/off
It is carried out by long pressing of the pushbutton OK,
choosing YES and then confirmation by short pressing of the
pushbutton OK.
