©JRI Maxant
21
Alarm LED (red) is on
during 10”.
+
T° OK: green LED is on
during 10”.
+
i)
Measurement stop
Depending on the configuration, the SPY RF can stop recording or not. The different options are:
Rolling memory: once the memory is full, the new values replace the old ones.
Full memory: the recorder stops when its memory is full.
With the software: you can put the SPY RF in standby mode with Sirius when you do not use your
recorder.
With the pushbutton: this option is valid only if the SPY RF is configured in transport mode with a
start by pushbutton.
j)
Auto control or top zone
The type of action depends on the SPY RF configuration.
TOP ZONE = Transport mode
and
AUTO CONTROL = Storage mode
This function enables you to customise an action of measurement check-up. You just have to press
shortly on the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software
Sirius
k)
Leds and pushbutton actions functioning
The green led is on 2’’ when the measurement starts and then flashes each 1’ in recording
mode. Specials functioning regarding the recorder using mode:
Device set up in storage mode
Pushbutton pressing
Mode
< 5"
5’’> pressing <10’’
OFF
-
The 2 leds are on and flash at
the same time.
Starting measurements
Pushbutton
Green led 2" = beginning of
measurements
-
Delayed (date & time)
-
-
Immediately
-
-
Mesure
Green led 10" = auto control
-
To stop your SPY RF, press between 5 and
10” on the button:
-
The 2 LEDs are on and then flash
alternatively.
-
The screen goes off, Halt goes on.
